CLAUDIA BIANCHI ZAMATARO
2 resultados
Resultados de Busca
Agora exibindo 1 - 2 de 2
Artigo IPEN-doc 27710 Morphological, optical, and elemental analysis of dental enamel after debonding laminate veneer with Er,Cr:YSGG laser2021 - ZANINI, NATHALIA A.; RABELO, THAIS F.; ZAMATARO, CLAUDIA B.; CARAMEL-JUVINO, AMANDA; ANA, PATRICIA A.; ZEZELL, DENISE M.Laminate veneer removal is becoming a routine procedure at the dental clinic and the use of laser can facilitate its removal. This work aimed to evaluate the morphological, elemental, and optical changes in the remaining enamel after veneer removal using Er,Cr:YSGG laser. Forty‐four enamel slabs were prepared and randomly distributed into nine experimental groups, for bonding using lithium disilicate laminates with three different luting agents (Variolink Veneer, RelyX U200, and RelyX Veneer). Then each agent was debonded using Er,Cr:YSGG laser (2.78 μm) using two different protocols:3.5 W, 48.14 J/cm2, 20 Hz non‐contact and 3.0 W, 48.14 J/cm2, 20 Hz non‐contact. The morphological, optical, and elemental analysis of enamel was performed before cementation and after laser debonding, using scanning electron microscopy (SEM), optical coherence tomography (OCT), and energy‐dispersive X‐ray spectroscopy (EDS). The level of statistical significance adopted was 5%. The EDS analysis of enamel after debonding revealed a significant increase in silane and carbon, as well as a decrease in calcium and phosphate contents. Analysis showed the presence of residual cement in most experimental groups but the morphological analysis showed alteration of the enamel's prisms only in the groups that used RelyX Veneer and Variolink Veneer cements. There was no evidence of deleterious morphological changes resulting from irradiation. However, an increase in the optical attenuation coefficient by the OCT was observed due to the presence of the remaining cement. It can be concluded that the Er,Cr:YSGG laser, in the mean powers used, is efficient for veneer removal without causing deleterious effects for the enamel.Artigo IPEN-doc 24864 Effect of 830 nm diode laser irradiation of root canal on bond strength of metal and fiber post2018 - STREFEZZA, CLAUDIA; AMARAL, MARCELLO M.; QUINTO JUNIOR, JOSE; GOUW-SOARES, SHEILA C.; ZAMATARO, CLAUDIA B.; ZEZELL, DENISE M.Objective and background: The correct selections of the cementing agent, the endodontic post material and placement protocol are critical to provide an increased longevity of the teeth that went through endodontic treatment. The irradiation with diode laser before post cementation, can promote an antimicrobial effect. However, there is a lack of information about the effect of 830 nm diode laser on the post bond strength. This study analyzed the effect of dentin root canal irradiation with high-intensity diode laser, at 830 nm, operating in continuous or pulsed mode, on the retention of metal or fiber posts, cemented with self-etching resinous composite (Panavia F) and zinc phosphate cement (ZnPO4). Materials and methods: Human roots were irradiated with diode laser (continuous and pulsed mode). The fiber posts were luted with Panavia F and the metal posts with Panavia F or ZnPO4 cement. Specimens were sectioned into three sections (cervical, middle, and apical). The bond strength was measured by a push-out mechanical analysis. For the statistical analysis, a three-way ANOVA test was applied following a Tukey's pairwise comparison with a significance level of p = 0.05. Results: The irradiated groups presented higher bond strength compared with nonirradiated group (p < 0.05), and the cervical and middle thirds presented higher on bond strength than the apical. The association of metal post and Panavia F presented higher bond strength when irradiated on continuous mode (p < 0.05). Fiber post and Panavia F presented higher bond strength associated to pulsed mode. The mode seems not to make a significant difference. Conclusions: These results corroborate the importance of the post bond to dentin and root canal debris removal to increase the tooth longevity. It was shown that the dentin to post bond strength were enhanced by the diode laser irradiation either on continuous or pulsed modes.