SABRINA GONCALVES DE MACEDO CARVALHO
2 resultados
Resultados de Busca
Agora exibindo 1 - 2 de 2
Artigo IPEN-doc 29902 W-doped Lanthanum Molybdenum Oxide/Lithium-Sodium-Potassium Carbonate Composite Membranes for Carbon Dioxide Permeation2023 - MEDINA, MIDILANE S.; CARVALHO, SABRINA G.M.; TABUTI, FRANCISCO N.; MUCCILLO, ELIANA N.S.; FONSECA, FABIO C.; MUCCILLO, REGINALDOSingle-phase tungsten-doped lanthanum molybdenum oxide (La2MoWO9) ceramic powders were synthesized using the complex polymerization technique. Porous ceramic pellets were obtained by thermally removing graphite, which served as a pore former. The porous pellets were then impregnated with molten eutectic lithium-sodium-potassium carbonates. The energy dispersive X-ray analysis and scanning electron microscopy (FEG-SEM) images of the external and fracture surfaces of the La2MoWO9-(Li,Na,K)2CO3 composite dual-phase membrane revealed the percolation of the carbonate mixture through the pores. Electrochemical impedance spectroscopy measurements conducted at temperatures below and above the melting point of the eutectic carbonate composition demonstrated the contributions of oxygen and carbonate ions to the ionic conductivity of the dual membrane. The electrical conductivity of the carbonate ions within the membrane was continuously monitored for over 1300 h with negligible degradation, implying that the membrane could be used for long-term monitoring of CO2 without aging effects. A comparison of FEG-SEM images taken before and after this endurance test suggested minimal fouling, indicating that the membrane could potentially replace similar zirconia- and ceria-based composite membranes.Artigo IPEN-doc 26438 Enhancement of the ionic conductivity in electric field-assisted pressureless sintered BITIVOX solid electrolytes2019 - MEDINA, MIDILANE S.; CARVALHO, SABRINA G.M.; MUCCILLO, ELIANA N.S.; MUCCILLO, REGINALDOBi4V1.8Ti0.2O11 (BITIVOX) ceramic pellets, prepared with powders obtained by a sol gel technique, were sintered either conventionally at 800 C/8 h or by applying an AC electric voltage, limiting the electric current through the pellets. Electric voltages were applied isothermally at 700 C and 800 C during 5 min in the green pellet positioned in the sample holder of a dilatometer for monitoring thickness variation. The BITIVOX pellets shrank 13.6% after applying 200 V cm1 at 800 C and 10.4% heating to 800 C for 8 h. Thermal analysis and X-ray di raction of the powders were performed to evaluate the crystallization temperature and the structural phase, respectively. The electrical behavior of the sintered BITIVOX pellets was analyzed by the impedance spectroscopy technique, showing that the sample flash sintered at 800 C/5 min had lower bulk resistivity than the sample conventionally sintered at 800 C/8 h. The surfaces of the sintered pellets were observed in a scanning electron microscope showing similar grain sizes and pore content in all sintered samples.