TALITA GISHITOMI FUJIMOTO
2 resultados
Resultados de Busca
Agora exibindo 1 - 2 de 2
Artigo IPEN-doc 29908 Mechanical and electrical characterization of 8YSZ-ScCeSZ ceramics2023 - FUJIMOTO, T.G.; SERIACOPI, V.; FERREIRA, L.A.S.; MACHADO, I.F.; MUCCILLO, E.N.S.The effects of small amounts (up to 5 wt.%) of scandia- and ceria-stabilized zirconia on the electrical conductivity, and the elastic modulus and hardness of yttria-stabilized zirconia were investigated by impedance spectroscopy and nanoindentation tests, respectively. The main purpose of this work was to obtain solid electrolyte compounds with improved properties compared to those of the base materials. Solid electrolytes compounds were prepared by solid-state reaction synthesis with sintering at 1450 ºC for 4 h. All prepared compounds exhibit a cubic fluorite-type structure. The microstructure of the compounds consists of polygonal grains with low (< 2%) porosity. The mean grain size estimated by the intercept method was 5 ± 1 μm. The electrical conductivity of the compound ceramics is lower than that of the base material. Addition of scandia-stabilized zirconia is found to exert a beneficial effect on the matrix by increasing the elastic modulus, achieving 221 MPa for 5 wt.% of the additive.Artigo IPEN-doc 26455 Influence of yttria-stabilized zirconia on microstructure and electrical properties of doped lanthanum gallate2019 - FUJIMOTO, TALITA G.; REIS, SHIRLEY L.; MUCCILLO, ELIANA N. dos S.Lanthanum gallate with partial substitutions for strontium and magnesium shows higher ionic conductivity than traditional ionic conductors such as yttria-stabilized zirconia (8YSZ), and has been considered for application as solid electrolyte and electrode in Solid Oxide Fuel Cells operating at intermediate temperatures (500-700ºC). Parallel to the development of new solid electrolytes, improvement of the already known electrolytes has been one goal. In this work, the effects of adding 8YSZ to La0.9Sr0.1Ga0.8Mg0.2O3-δ (LSGM), on the microstructure and electrical performance were investigated. Compound electrolytes consisting of up to 20 wt.% 8YSZ were prepared by solid state reactions. Sintered pellets with up to 10 wt.% 8YSZ achieved near full density after sintering at 1450ºC and reduction in the fraction of impurity phases. Addition of 8YSZ promoted grain growth to LSGM. The higher ionic conductivity was obtained for 1 wt.% 8YSZ addition with slight decrease of the apparent activation energy.