A DC design of an X-band traveling-wave tube
Carregando...
Data
Data de publicação:
2013
Autores IPEN
Orientador
Título da Revista
ISSN da Revista
Título do Volume
É parte de
É parte de
É parte de
É parte de
INTERNATIONAL MICROWAVE AND OPTOELECTRONICS CONFERENCE
Exportar
Resumo
In this paper a dc design procedure of a X-band
traveling-wave tube is described. This procedure consists in
determine the geometry of the electron gun, the periodic
permanent magnetic and the electron collector. It was found that
an electron gun with a 0.26 μPerv, 9.1 kV, 225 mA and 0.6 mm
beam radius without electrostatic beam control was suitable for
this design. The PPM, constructed with samarium-cobalt
magnetics shown a good agreement with theoretical design.
Finally a three stage depressed collector, to recover part of nonused
electron energy and improve the overall electronic efficiency
of TWT, is presented. The simulations were run with Particle-incell
Studio.
Como referenciar
XAVIER, CESAR C.; MOTTA, CLAUDIO C. A DC design of an X-band traveling-wave tube. In: INTERNATIONAL MICROWAVE AND OPTOELECTRONICS CONFERENCE, August 04-07, 2013, Rio de Janeiro, RJ. Proceedings... Piscataway, NJ: IEEE, 2013. DOI: 10.1109/imoc.2013.6646550. Disponível em: http://repositorio.ipen.br/handle/123456789/27651. Acesso em: 19 Feb 2025.
Esta referência é gerada automaticamente de acordo com as normas do estilo IPEN/SP (ABNT NBR 6023) e recomenda-se uma verificação final e ajustes caso necessário.