CAIO ALMEIDA JUSTINO DA SILVA
2 resultados
Resultados de Busca
Agora exibindo 1 - 2 de 2
Artigo IPEN-doc 29130 Analyses of magnesium-based alloys by nuclear techniques2022 - SILVA, C.A.J.; BRAGUIN, L.N.M.; ROSSI, J.L.; SCAPIN, M.A.; COSTA, I.; SAIKI, M.Magnesium-based alloys have been proposed for use in temporary biomaterials in the applications that request their biocompatibility and degradability. Analyses of these alloys are of great interest to verify if their element composition is within the product specification and also to evaluate the impurities that may cause toxic effects to the human health or influence in their corrosion processes. In this study, nuclear techniques of neutron activation analysis (NAA) and wavelength dispersive X ray fluorescence spectrometry (WD XRFS) were applied in the analyses of two magnesium-based alloys: commercially pure magnesium (CP-Mg) and AZ31 alloy. The NAA procedure consisted of irradiation aliquots of sample and synthetic element standards followed by measurements using a HGe detector and the WD XFRS was carried out using the Model RIX 3000 X-ray spectrometer. In the CP-Mg sample several element impurities were quantified. In the AZ31 alloy, the alloying element mass fractions were within the product specification and the impurities of As, La, Na and Sb were also quantified. Nickel and sulfur were quantified only by WD XFRS. The Horwitz method was a good parameter to evaluate the repeatability of the results in Al, Mg, Mn and Zn determinations. In conclusion, the results indicated the viability of using NAA and WD XFRS in the analyses of magnesium-based materials mainly due its multielement determinations, precision of the results, quantification of elements in a wide range of mass fractions and the lack of need for sample dissolution.Artigo IPEN-doc 27919 Determination of chemical elements in magnesium-based materials by neutron activation analysis2021 - SILVA, C.A.J.; BRAGUIN, L.N.M.; ROSSI, J.L.; COSTA, I.; SAIKI, M.Over the last decades there was an increasing interest in using magnesium alloys for medical applications due to their biodegradability in the human body, providing a temporary mechanical support and corroding completely after the tissue healing. Although magnesium is a non-toxic element, it is of great importance to evaluate the element concentration, as well as the impurities present in both, pure magnesium and magnesium alloys, as the AZ31. The purpose of this study was to analyze the element composition of these materials using the method of neutron activation analysis (NAA). Standard Reference Materials (SRMs) acquired from National Institute of Standards and Technology (NIST) were analyzed for analytical quality control. Short and long term irradiations were carried out at the IEA-R1 nuclear research reactor and gamma-ray activities induced to the samples and element standard were measured using HPGe detector coupled to a Digital Spectrum Analyzer. The radioisotopes were identified by gamma ray energies and half-life. Concentrations of the elements As, Cr, Cd, Co, Fe, In, La, Mg, Mn, Mo, Na, Sb, V, W and Zn were determined in pure magnesium sample and the Al, As, La, Mg, Mn, Na, Sb and Zn in the AZ31 alloy, calculated by comparative method. The SRMs were analyzed by applying the same experimental conditions used for magnesium-based materials and their results presented good accuracy and precision. Thus, from the measurements obtained in this study it can be concluded that NAA is a suitable method for element determinations in magnesium-based materials providing reliable results.