IZABEL DA SILVA ANDRADE
2 resultados
Resultados de Busca
Agora exibindo 1 - 2 de 2
Artigo IPEN-doc 30209 Comparison of PBL heights from ceilometer measurements and greenhouse gases concentrations in São Paulo2023 - SANTOS, AMANDA V. dos; ARAUJO, ELAINE C.; ANDRADE, IZABEL da S.; CORREA, THAIS; MARQUES, MARCIA T.A.; SOUTO-OLIVEIRA, CARLOS E.; LEONARDO, NOELE F.; MACEDO, FERNANDA de M.; SOUZA, GIOVANNI; LOPES, PEROLA P. de Q.; MOREIRA, GREGORI de A.; ANDRADE, MARIA de F.; LANDULFO, EDUARDOThis paper presents a study conducted in São Paulo, Brazil, where the planetary boundary layer height (PBLH) was determined using ceilometer data and the wavelet covariance transform method. The retrieved PBLH values were subsequently compared with the concentrations of CO2 and CH4 measured at three distinct experimental sites in the city. The period of study was July 2021. This study also included a comparison between ceilometer data and lidar data, which demonstrated the favorable applicability of the ceilometer data for PBLH estimation. An examination of the correlation between changes in average CO2 concentrations and PBLH values revealed stronger correlations for the IAG and UNICID stations, with correlation coefficients (ρ) of approximately −0.86 and −0.85, respectively, in contrast to the Pico do Jaraguá station, which exhibited a lower correlation coefficient of −0.42. When assessing changes in CH4 concentrations against variations in PBL height, the retrieved correlation coefficients were approximately −0.78 for IAG, −0.66 for UNICID, and −0.38 for Pico do Jaraguá. The results indicated that CO2/CH4 concentrations are negatively correlated with PBL heights, with CO2 concentrations showing more significant correlation than CH4 . Additionally, among the three measurement stations, IAG measurements displayed the most substantial correlation. The results from this study contribute to the understanding of the relationship between PBLH and greenhouse gas concentrations, emphasizing the potential of remote sensing systems like ceilometers in monitoring and studying atmospheric processes.Artigo IPEN-doc 28401 Methane detection in the lower troposphere related to the burning of biomass and leakage in a petrochemical pole, using Raman lidar technique2021 - MACEDO, FERNANDA de M.; CORREA, THAIS; ARAUJO, ELAINE C.; ANDRADE, IZABEL da S.; GUARDANI, ROBERTO; VESELOVSKII, IGOR; LANDULFO, EDUARDOFugitive emissions, defined as unintended or irregular leaks of gases and vapors, are an important source of pollutants to the atmosphere, which is difficult to monitor and control. These sources are present in different sites, especially in regions that are growing in size and economic activity. In this study, we present the results of the capability to detect methane profiles at low troposphere combining data retrieval correlations between a rotacional/vibracional Raman lidar (RVRL) and a cavity ring-down spectrometer (CRDS). The measurements were made at two different sites, metropolitan area of São Paulo (MSP) and industrial area of Cubatão (IC). The lidar is based on a tripled Nd:YAG laser with a 20 Hz repetition rate, operating on the 355 nm wavelength elastic channel, the 353 nm and 396 nm wavelength inelastic channels. A measurement protocol was established, considering acquisition time for signal accumulation, climatic conditions and data above and below the planetary boundary layer. The idea was to establish specific measurement procedures for situations related to product leakage in the oil process and natural events, such as biomass burning. With over 150 hours of data acquisition, the results pointed the possibility of analyzing data from distances up to 1500 m with an initial resolution of 7.5 m which was extended to 100 - 300 m after data smoothing for obtaining final results. The concentration was calculated from the ratio between the methane Raman backscatter signal and the nitrogen signal, at 396 nm and 353 nm, respectively. The temporal variation of methane concentrations was correlated with CRDS data, in order to obtain a first degree calibration.