BIANCA ALVES MARCELLO
2 resultados
Resultados de Busca
Agora exibindo 1 - 2 de 2
Resumo IPEN-doc 23313 Influência da morfologia no desempenho fotocatalítico de filmes de TIO22017 - MARCELLO, B.A.; GERIBOLA, G.A.; DE ARAUJO, E.G.; PILLIS, M.F.Dióxido de titânio apresenta estabilidade química em diversos meios, apresenta boa resistência mecânica e à corrosão, fotoestabilidade, e significativa atividade fotocatalítica. Trata-se do semicondutor mais utilizado como fotocatalisador. Neste trabalho filmes de TiO2 com espessura de aproximadamente 400 nm foram crescidos a 400 e 500ºC sobre borossilicato utilizando a técnica de deposição química de organometálicos em fase vapor. Análises por difração de raios-X sugerem a formação de somente anatase em ambos os casos. Os filmes crescidos a 400ºC apresentaram direção preferencial de crescimento (200), enquanto que os crescidos a 500ºC apresentaram crescimento preferencial na direção (112). As análises obtidas por microscopia eletrônica de varredura mostram que o filme crescido a 400ºC apresenta morfologia colunar densificada, e o filme crescido a 500º apresenta morfologia colunar porosa. O desempenho fotocatalítico dos filmes foi avaliado por espectrofotometria UV medindo-se os valores de absorbância em uma solução aquosa de concentração 5 mg/L, e pH 2 de alaranjado de metila, após 5h sob luz UV. Os resultados de degradação indicam um desempenho muito superior do filme crescido a 400ºC, o que sugere que a morfologia dos filmes tem papel importante na fotocatáliseResumo IPEN-doc 23680 Evaluation of the photocatalytic activity of TiO2 films grown by mocvd technique2016 - MARCELLO, BIANCA A.; GERIBOLA, GUILHERME A.; ARAUJO, EDVAL G.; PILLIS, MARINA F.The presence of pollutants such as insecticides and antibiotics in wastewaters and drinking water is nowadays one of the major environmental problems. Titanium dioxide has emerged as an excellent photocatalyst for pollutant degradation. In this research TiO2 films with thicknesses of 184, 395 and 720 nm were grown at 400ºC by metallorganic chemical vapor deposition (MOCVD) on borosilicate substrates. Titanium isopropoxide IV was used both as titanium and oxygen precursors. The films were analyzed by x-ray diffraction and the results suggested that anatase was the only phase formed. The photocatalytic behavior of the TiO2 films on the degradation of methyl orange dye solution in different values of pH was evaluated by spectrophotometry under UV irradiation. The results of the dye degradation show that the lower the pH of the solution, the higher the efficiency of the TiO2, independently of the thickness of the film. The best photocatalytic performance was observed for films with 395 nm of thickness at pH 2.00, which showed 65.3% of efficiency in the degradation of the dye. Similar result was obtained by Duminica et al.1 that grew TiO2 films by MOCVD and reported the best result for films with approximately 300 nm of thickness. According to these authors, when the film is very thick and dense, most of the pairs electron/hole is generated inside the film, and do not reach the surface, and when the film is very thin, only a small portion of the incident light is absorbed by TiO2. Thus, there is an optimal thickness to obtain the best results. The findings of the present study permit to conclude that TiO2 films produced by MOCVD are promising for application as photocatalyst material in the degradation of organic pollutants as methyl orange dye.