Mechanical, structural and thermodynamic features of high energy milled Cr3C2-25(Ni20Cr) composite powders
Carregando...
Data
Data de publicação:
2018
Orientador
Título da Revista
ISSN da Revista
Título do Volume
É parte de
É parte de
É parte de
É parte de
CONGRESSO BRASILEIRO DE ENGENHARIA E CIÊNCIA DOS MATERIAIS, 23.
Exportar
Resumo
This paper presents mechanical, microstructural and thermodynamic features of
Cr3C2-25(Ni20Cr) powders that were high energy milled for different times. Severe
plastic deformation is introduced in the powders and a small part of the energy spent
in the process is stored in the crystal lattice. Crystallite size, microstrain and lattice
parameter of the powders were determined using x-ray diffraction measurements
(Rietveld method). The evolution of microstrain with crystallite size revealed a critical
crystallite size (DCRIT = 28 nm; tMill = 16 h), where the microstrain reached a
maximum [?MAX (%) = 1.17], and then decreased. The lattice parameter showed an
opposite behavior (aMIN = 3.5417A). This suggested occurrence of “size effects” and
aspects related to strain gradient plasticity are discussed. Stored energy in the crystal
lattice was determined from enthalpy variation of the powders, and the graph of ?H vs
1/D also showed a maximum (?HMAX = 722 mcal) for powders milled for 16 h.
Microstructural features like small angle grain boundaries and microtwins where
studied by TEM. The influence of grain boundaries on microstrain was studied.
Modifications in microstructure are discussed based on dislocation density, which is
related to crystallite size and microstrain in the crystal lattice. A model for dislocation
density evolution has been suggested. The dislocation density at the critical crystallite
size was around 1.7 x 1011 cm-2. The dimensions of the slip bands in the material
were estimated (xMAX = 3.1 ?m).
Como referenciar
RAMANATHAN, L.V.; CORREA, O.V.; LIMA, N.B.; CUNHA, C.A. da; SAYEG, I.J. Mechanical, structural and thermodynamic features of high energy milled Cr3C2-25(Ni20Cr) composite powders. In: CONGRESSO BRASILEIRO DE ENGENHARIA E CIÊNCIA DOS MATERIAIS, 23., 04-08 de novembro, 2018, Foz do Iguaçu, PR. Resumo... p. 2107-2107. Disponível em: http://repositorio.ipen.br/handle/123456789/29516. Acesso em: 13 Mar 2025.
Esta referência é gerada automaticamente de acordo com as normas do estilo IPEN/SP (ABNT NBR 6023) e recomenda-se uma verificação final e ajustes caso necessário.