Analysis of the influence of continuous-drive friction welding on the microstructure and mechanical properties of the UNS C64200 bronze-aluminum-silicon alloy
Carregando...
Data
Data de publicação
Orientador
Título da Revista
ISSN da Revista
Título do Volume
É parte de
É parte de
É parte de
Defect and Diffusion Forum
Exportar
Resumo
Friction welding (FRW) is an important commercial solid-state welding process in which
coalescence is achieved by frictional heat combined with pressure. The objective of this work is to
analyze the microstructure and the mechanical behavior of the copper alloy UNS C64200 – bronze-aluminum-
silicon, as well as to raise the ideal welding parameters so that there is adequate weldability
after process of continuous-drive friction welding. Regarding the analysis of the microstructure,
scanning electron microscopy was used to characterize phases. The mechanical properties were
evaluated by means of a hardness test of the center of the welded joint, traversing the entire extent of
the thermally affected zone. Results show that the UNS C64200 alloy, when subjected to conventional
friction welding, behaves satisfactorily in terms of weldability, without the appearance of cracks or
defects arising from the temperature characteristic of this process, as well as good hardness with
values above the minimum established in norm and higher than the base material.
Como referenciar
MONTEIRO, P.S.P.; SANTOS, G.A. dos; NAKAMOTO, F.Y.; NASCIMENTO, M.S.; TERAM, R.; SANTOS, V.T. dos; SILVA, M.R. da; COUTO, A.A.; MACHADO, I.F.; BRANDI, S.D. Analysis of the influence of continuous-drive friction welding on the microstructure and mechanical properties of the UNS C64200 bronze-aluminum-silicon alloy. Defect and Diffusion Forum, v. 412, p. 185-195, 2021. DOI: 10.4028/www.scientific.net/DDF.412.185. Disponível em: http://repositorio.ipen.br/handle/123456789/32878. Acesso em: 30 Dec 2025.
Esta referência é gerada automaticamente de acordo com as normas do estilo IPEN/SP (ABNT NBR 6023) e recomenda-se uma verificação final e ajustes caso necessário.