Machining and mechanical characterization of PM materials for valve seat inserts

Carregando...
Imagem de Miniatura
Data
2005
Data de publicação:
Orientador
Título da Revista
ISSN da Revista
Título do Volume
É parte de
É parte de
É parte de
Materials Science Forum
Exportar
Mendeley
Projetos de Pesquisa
Unidades Organizacionais
Fascículo
Resumo
This article shows some fabrication aspects related to the obtention of sintered valve seat insert. This insert was made of a mixture of high-speed steel powders and iron powders plus NbC. This is a new development aiming the substitution of Co alloys currently used for valve seat inserts. The physical properties, mechanical properties and machining behaviour are discussed. The machining characteristics in terms of tool wear, cutting forces and chips morphology of the insert was compared to available commercial insert. The machining results indicate that the material under development has potential for commercial application and shows good machining evidences, in terms of equivalent cutting forces for ceramic tool. In addition, the machining using hard metal tool was susceptible to hardness variation observed for the material under development. Therefore, the machining tests point out the necessity for a microstructure homogenisation of the obtained material.

Como referenciar
JESUS FILHO, E.S.; SALGADO, L.; JESUS, S.L.; ROSSI, J.L.; COLOSIO, M.A.; SANTOS, J.C. Machining and mechanical characterization of PM materials for valve seat inserts. Materials Science Forum, v. 498/499, p. 79-84, 2005. DOI: 10.4028/www.scientific.net/MSF.498-499.79. Disponível em: http://repositorio.ipen.br/handle/123456789/5501. Acesso em: 15 Mar 2025.
Esta referência é gerada automaticamente de acordo com as normas do estilo IPEN/SP (ABNT NBR 6023) e recomenda-se uma verificação final e ajustes caso necessário.

Agência de fomento
Coleções